Mitre saw stop

Official

The stop homes on its limit switch, then moves to the length measured from the blade. Change the length and run it again for the next cut. The device refuses any length past the end of the fence.

Hardware: UPAN Core · 1 axis
Contains: Program, Phrases for an agent
Version: 0.1.0
Minimum firmware: not released yet

Parameters

LengthmmFrom 0 to 5000Speedmm/sFrom 1 to 1000

The device accepts this programChecked on the demo machine of Woodworking: 0–1200 mm, ≤ 400 mm/s. Your machine checks against its own limits.

Program

{
  "program": [
    {
      "home": true
    },
    {
      "move_abs": "742.5mm",
      "velocity": "250mm/s"
    }
  ]
}

Change with the agent API

Try it

Position380.0mm

Velocity0mm/s

You say

…

The agent writes the program

A demo axis in your browser, on a model of the firmware rules. On the board the program comes from the controller screen, our agent — or your own AI tool, if you like.

UPAN Core checks it

Limits stored in the controller

Travel: 0–1200 mm
Max speed: 400 mm/s
Max acceleration: 2000 mm/s²

Install

Install codeP-7K3Q

On the device's control page: enter P-7K3Q.
Without internet: download the file and drop it on the control page.
With an agent: ask it to install preset P-7K3Q.

Not final: installing by code needs controller firmware that is still in development. The file and the API work today.

Phrases for an agent

Set the stop to 742.5 mm.
Move the stop 10 mm further.